This bracket clamps on two the steering head with the provided
U-bolt. The bracket has two dowels that slide down over the steering
stop. It will connect to the upper fairing above the headlight.
The two L-shaped tabs reach up through the frame to the
bolts on the coil mounts, the bracket than hangs down from those
bolts. The ends of the bracket will connect to the recessed bosses
on the sides of the upper fairing.
Click here for
Bolts on to the tabs on the side of the chassis. Top
holes then line up to recessed bosses on seat. The tail light/license
plate bracket bolts to the inner fender mounting bolts.
The fiberglass supper bracket goes right underneath the rider's
butt, flat side down, to support rider's weight. Stick the seat
on, reach up from the bottom and wiggle the support bracket around
until it slides into the correct position. It can be rivited to
the frame or epoxied to the seat, your choice.